TEXT NF \ 
 0.3 or older
 0.4 or newer
Are left and right Z~carriages all up?
Auto power
Calibrating XYZ. Rotate the knob to move the Z carriage up to the end stoppers. Click when done.
Calibrating Z. Rotate the knob to move the Z carriage up to the end stoppers. Click when done.
Cont.
Current
FS Action
FS v0.4 or newer
High power
Insert the filament (do not load it) into the extruder and then press the knob.
MK3S firmware detected on MK3 printer
Pause
Please unload the filament first, then repeat this action.
Prusa i3 MK2.5 OK.
Prusa i3 MK2.5S OK.
Prusa i3 MK3S OK.
Sensor verified, remove the filament now.
Show end stops
Unload
Use unload to remove filament 1 if it protrudes outside of the rear MMU tube. Use eject if it is hidden in tube.
Used during print
Verification failed, remove the filament and try again.
[%.7s]Live adj. Z\x0avalue set, continue\x0aor start from zero?\x0a%cContinue%cReset
