From 4258ecef36f1b32012663b0b8728573876e5d0f1 Mon Sep 17 00:00:00 2001 From: Yuri D'Elia Date: Thu, 29 Dec 2022 12:56:16 +0100 Subject: [PATCH] README: Fix formatting --- README.md | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/README.md b/README.md index 409257ac5..95c14da86 100644 --- a/README.md +++ b/README.md @@ -147,7 +147,7 @@ After updating the kit, you may need to reload VScode. #### Building -To start building a firmware, click the CMake Tools plugin icon on the far left side. You will get a very large list of targets to build. Find the firmware you'd like to build (like `MK3S-EINSy10a_ENGLISH`)and select the small icon which shows "Build" when hovered over. +To start building a firmware, click the CMake Tools plugin icon on the far left side. You will get a very large list of targets to build. Find the firmware you'd like to build (like `MK3S-EINSy10a_ENGLISH`) and select the small icon which shows "Build" when hovered over. The built .hex file can then be found in folder `Prusa-Firmware/build` @@ -187,10 +187,10 @@ Run "Arduino IDE", then - Open the file `Firmware/Firmware.ino` - Select the target board with Tools -> Board -> "PrusaResearch Einsy RAMBo" -- Open `Firmware/config.h` and change LANG_MODE to 0. +- Open `Firmware/config.h` and change `LANG_MODE` to 0. ### Compilation and upload -- Run the compilation Sketch -> Verify/Compile -- Upload the result code into the connected printer Sketch -> Upload +- Run the compilation: Sketch -> Verify/Compile +- Upload the result code into the connected printer: Sketch -> Upload