diff --git a/Firmware/Marlin_main.cpp b/Firmware/Marlin_main.cpp
index f3cfcb812..836289e87 100644
--- a/Firmware/Marlin_main.cpp
+++ b/Firmware/Marlin_main.cpp
@@ -3004,7 +3004,7 @@ static void gcode_G80()
     babystep_apply(); // Apply Z height correction aka baby stepping before mesh bed leveing gets activated.
     bool eeprom_bed_correction_valid = eeprom_read_byte((unsigned char*)EEPROM_BED_CORRECTION_VALID) == 1;
     const constexpr uint8_t sides = 4;
-    int8_t correction[sides] = {0};
+    int8_t correction[sides];
     for (uint8_t i = 0; i < sides; ++i) {
         static const char codes[sides] PROGMEM = { 'L', 'R', 'F', 'B' };
         static uint8_t *const eep_addresses[sides] PROGMEM = {
@@ -3013,23 +3013,21 @@ static void gcode_G80()
           (uint8_t*)EEPROM_BED_CORRECTION_FRONT,
           (uint8_t*)EEPROM_BED_CORRECTION_REAR,
         };
-        if (code_seen(pgm_read_byte(&codes[i])))
-        { // Verify value is within allowed range
+        if (code_seen(pgm_read_byte(&codes[i]))) {
+            // Verify value is within allowed range
             int32_t temp = code_value_long();
             if (labs(temp) > BED_ADJUSTMENT_UM_MAX) {
-                SERIAL_ERROR_START;
-                SERIAL_ECHOPGM("Excessive bed leveling correction: ");
-                SERIAL_ECHO(temp);
-                SERIAL_ECHOLNPGM(" microns");
+                printf_P(PSTR("%SExcessive bed leveling correction: %li microns\n"), errormagic, temp);
                 correction[i] = 0;
             } else {
               // Value is valid, save it
               correction[i] = (int8_t)temp;
             }
-        } else if (eeprom_bed_correction_valid)
+        } else if (eeprom_bed_correction_valid) {
             correction[i] = (int8_t)eeprom_read_byte((uint8_t*)pgm_read_ptr(&eep_addresses[i]));
-        if (correction[i] == 0)
-            continue;
+        } else {
+            correction[i] = 0;
+        }
     }
     for (uint8_t row = 0; row < MESH_NUM_Y_POINTS; ++row) {
         for (uint8_t col = 0; col < MESH_NUM_X_POINTS; ++col) {