2120d17912
optimisation: simplify T-code response for single material
...
Extruder is always 0
Change in memory:
Flash: -12 bytes
SRAM: 0 bytes
2023-04-15 13:45:08 +00:00
4d90ecbcc4
cleanup: remove ctype include
...
We don't use any function from this header
No change in code size
2023-04-15 13:45:08 +00:00
a20a7232a8
Change "Extruder N" to "Filament N"
...
Change in memory:
Flash: -52 bytes
SRAM: 0 bytes
2023-03-06 10:26:12 +01:00
edad625cf7
RIP Bondtech long live the Extruder
2022-09-16 16:31:27 +02:00
b292a5bf4e
PFW-1362 temporarily don't use SpoolJoin in Tcodes
...
I think in the current implementation, this will cause more harm than good.
But we can improve SpoolJoin later
2022-09-16 10:23:47 +02:00
715af8fcc2
Rename files to SpoolJoin
2022-09-16 10:23:47 +02:00
afc67332c7
PFW-1362 Initial commit
2022-09-16 10:23:47 +02:00
fae420f1e2
Fix MMU_ALWAYS_CUT enabled in variants
2022-09-16 10:23:47 +02:00
09cb9c6ecd
Fixup after rebase + discussion
2022-09-16 10:22:38 +02:00
204b43dce4
PFW-1336
...
The following situation is now fixed, steps:
1. Load filament through LCD
2. Load to nozzle through LCD
3. Before filament reaches Fsensor => turn off the printer
4. Wait a few seconds and then turn the printer on again
5. Start a print through the SD card
6. Printer will unload and then re-load the filament
Previously in step 6, the printer would start a print without any
filament loaded.
2022-09-16 10:22:38 +02:00
0bd3dfdcf7
This starts to print ;)
...
Temporarily disabled filament runout as this breaks ToolChange operation
yet for unknown reason.
2022-09-16 10:22:38 +02:00
4fa4b3b2fc
Refactor Tx/Tc/T? commands
2022-09-16 10:21:53 +02:00
2e293e90a0
MMU2 interface overhaul
...
First port of the new MMU2-printer interface into 8bit FW.
2022-09-16 10:21:53 +02:00
Guðni Már Gilbert
3d-gussner
D.R.racer