ad702c6d1f
improved algorithm for first hit, improving sensor point changed, just one calibration round for 4point heatbed (no second run for improving measured coordinates)
2018-03-04 20:21:31 +01:00
815dfcb14b
Implemented a stepper timer reset after a long blocking cli()
...
or DISABLE_STEPPER_DRIVER_INTERRUPT().
If this is not done, the stepper interrupt would likely overflow,
leading to a maximum 32ms delay before the stepper interrupt wakes up.
In addition, the stepper timer overflow error would be reported
by the debug builds.
2018-01-20 15:39:21 +01:00
6eb57da770
fan check can be turned off from support menu, saving parameters to eeprom with offset and different levels, fan kickstart,2nd heatbed version, fans check modified
2017-09-21 15:20:02 +02:00
06fe85e9ee
Linear Advance
2017-07-07 01:58:02 +02:00
54ef2936c7
selftest
2017-07-06 13:19:11 +02:00
c4307c7373
TMC2130 tunning, overtemp
2017-07-03 00:11:42 +02:00
f6a8e1df9d
TMC2130 + software SG homing + LF lineendings + tmc2130 debug M-Codes
...
M910 - tmc2130_init
M911 - set holding currents
M912 - set running currents
M913 - print currents
2017-07-01 12:39:16 +02:00
43d696659f
3.0.12-RC2 sync
2017-06-29 18:35:43 +02:00
0578ea527e
fan speed check initial version, selftest updated
2017-06-28 14:24:45 +02:00
21177476ac
StallGuard homing implemented, working
2017-06-17 16:58:36 +02:00
c83b1833bc
Johhny Firmware sync
2017-06-17 15:42:48 +02:00
307d17422d
3.0.6 sync
2016-08-11 10:42:53 +02:00
30f0528aba
Initial commit
2016-07-22 15:28:01 +02:00
PavelSindler
bubnikv
michalprusa
Robert Pelnar