josh
/
Prusa-Firmware
1
0
Fork 0
Code Issues Pull Requests Packages Projects Releases Wiki Activity
6,268 Commits 31 Branches 140 Tags 71 MiB
Commit Graph

6 Commits

Author SHA1 Message Date
3d-gussner fae420f1e2 Fix MMU_ALWAYS_CUT enabled in variants 2022-09-16 10:23:47 +02:00
D.R.racer 09cb9c6ecd Fixup after rebase + discussion 2022-09-16 10:22:38 +02:00
Guðni Már Gilbert 204b43dce4 PFW-1336 
The following situation is now fixed, steps:
1. Load filament through LCD
2. Load to nozzle through LCD
3. Before filament reaches Fsensor => turn off the printer
4. Wait a few seconds and then turn the printer on again
5. Start a print through the SD card
6. Printer will unload and then re-load the filament

Previously in step 6, the printer would start a print without any
filament loaded.
 2022-09-16 10:22:38 +02:00
D.R.racer 0bd3dfdcf7 This starts to print ;) 
Temporarily disabled filament runout as this breaks ToolChange operation
yet for unknown reason.
 2022-09-16 10:22:38 +02:00
D.R.racer 4fa4b3b2fc Refactor Tx/Tc/T? commands 2022-09-16 10:21:53 +02:00
D.R.racer 2e293e90a0 MMU2 interface overhaul 
First port of the new MMU2-printer interface into 8bit FW.
 2022-09-16 10:21:53 +02:00