josh
/
Prusa-Firmware
1
0
Fork 0
Code Issues Pull Requests Packages Projects Releases Wiki Activity
Firmware for Original Prusa i3 3D printer by PrusaResearch
4 Commits 31 Branches 140 Tags 71 MiB
C++ 75.9%
C 14.4%
CMake 3.7%
Python 3.4%
Shell 2.1%
Other 0.3%
Go to file
bubnikv b470e103dc Reset live adjust on XYZ calibration. 
Disable timeouts in the XYZ/Z calibration.
Don't modify feed rate multiplier during the XYZ/Z calibration.
Support multi screen messages in the XYZ/Z calibration - "move the Z carriages up" step.
Support up to three lines in the XYZ/Z calibration messages.
Added a new message "Measuring reference height of calibration point xx of 9".
Changed the "move the Z carriages up" message to suggest rotating the knob.
Changed the "live adjust not set" message to reference the manual chapter and section.
Remove debugging serial line output on Z calibration.
 		2016-09-01 10:44:24 +02:00
ArduinoAddons 3.0.6 sync 2016-08-11 10:42:53 +02:00
Firmware Reset live adjust on XYZ calibration. 2016-09-01 10:44:24 +02:00
LICENSE 3.0.6 sync 2016-08-11 10:42:53 +02:00
README.md 3.0.6 sync 2016-08-11 10:42:53 +02:00

README.md

Original Prusa i3 MK2 Firmware

General instructions

Pre-compiled hex output on PRUSA RESEARCH site: http://prusa3d.com/downloads/firmware/

Just download and flash it to the electronics

Build instructions

Step 1

Install arduino

Step 2

Remove Liquid Crystal library from your arduino or rename it

Step 3

Install the arduino addon located in the root of this repo. Don't forget to install correct version!

Step 4

Copy the configuration file matching your printer from variants folder to the the Firmware folder

Step 5

Rename it to "Configuration_prusa.h"

Step 6

Compile the firmware

Step 7

Upload the firmware to board