Markus Amsler
|
3a271ee487
|
intercom: make sure extruder switches to listen mode
|
2011-04-04 09:12:53 +10:00 |
Michael Moon
|
2340808695
|
start implementing intercom protocol rehash
|
2011-03-05 13:38:12 +11:00 |
|
Michael Moon
|
d0601716e8
|
reorganise intercom to send packets from extruder main loop, also generalise protocol as discussed in forum
|
2011-03-05 13:38:12 +11:00 |
Markus Amsler
|
3647c6f1a9
|
intercom: extruder only replies if talked to
|
2011-02-27 23:05:33 +01:00 |
|
Markus Amsler
|
5e56784ac1
|
extruder: Set/get bed temperature.
|
2011-02-21 15:52:16 +11:00 |
|
Markus Amsler
|
6d83bdb067
|
extruder: add fan definitions
|
2011-02-21 15:52:15 +11:00 |
|
Markus Amsler
|
e032cf5dab
|
extruder: Use pull up resistors for step/dir pin to avoid noise.
|
2011-02-21 15:52:15 +11:00 |
|
Markus Amsler
|
d0cbe86a2d
|
extruder: Half-step on every step signal.
No idea why only every 4th step signal would actually step, but this generates a lot of noise for nothing.
|
2011-02-21 15:52:15 +11:00 |
|
Markus Amsler
|
e3672da1cf
|
extruder: Check the step pin directly.
Flag could get out of sync, with undefined results.
|
2011-02-21 15:52:15 +11:00 |
|
Markus Amsler
|
e41e659e66
|
intercom: Disable rx while doing tx. Avoids local RS485 half-duplex echo.
Signed-off-by: Michael Moon <triffid.hunter@gmail.com>
|
2011-02-14 11:31:45 +11:00 |
|
Michael Moon
|
b1a48994dd
|
preliminary untested implementation of Markus Amsler's new extruder comms protocol
|
2011-02-12 23:59:19 +11:00 |
|
Michael Moon
|
266c6ee0e2
|
merge release-candidate-triffid
|
2011-01-07 23:29:32 +11:00 |