df693c0113
config.h/dda.c: make endstop debouncing steps configurable.
2011-10-23 19:51:46 +02:00
448df5d1c3
config.*.h: raise default acceleration values.
...
Recommendation by Sublime, see
http://forums.reprap.org/read.php?147,99780,99912#msg-99912
2011-10-05 14:13:44 +02:00
e88becbad9
Config: don't enable soft axis limits by default.
...
This is confusing for newbies when their host of choice tries
to move into negative space.
You know ...
"Just installed Teacup and it's trash, because motors don't move!"
2011-10-05 14:13:32 +02:00
2eff194cdf
Rename STEPPER_ENABLE_INVERT to STEPPER_INVERT_ENABLE.
...
No functional change, just match the naming of single stepper
enable pins.
2011-10-05 14:13:28 +02:00
b4ad459e86
Distribute PS_ON_PIN and STEPPER_ENABLE_PIN to all config templates.
2011-10-05 14:13:19 +02:00
f9a4495aa1
Introduce TEMP_NONE, a "sensor" just storing the target temperature.
...
This is useful when operation a milling spindle. In this case,
set the spindle speed with M104 Sxxx, where xxx is 1..255.
M104 S0 turns the spindle off.
2011-09-01 19:03:33 +02:00
58f4678253
Catch by RobertFach: compatibility option for RepRap Host 20110509.
2011-08-30 12:01:48 +02:00
c2e7da519a
Changed and tested pin definitions based on RAMPS v1.3 schematics.
2011-08-16 13:24:59 +02:00
41f0d4050b
Created a new config file for the RAMPS v1.3 shield. Duplicated config.ramps.h to start with.
2011-08-16 13:23:27 +02:00
Markus Hitter
Bas Laarhoven