This code was introduced with v3.8.0 but was always disabled.
I propose the code be removed since it has not been enabled
for 3 years since its introduction.
- Work-around SOURCE flags being reset for each project when setting the
random-seed property by calling a support function.
- Likewise, set correct flags for reproducibility when creating archives.
- Strip source prefix paths from debug info
This should set the EPOCH using the last git commit date when available,
but it's not currently implemented. Just set the EPOCH to be 0 for now.
We want to move the Z-axis after the XY move is done.
raise_z cannot be used here because it relies
on current_position[] for all axis.
It is actually 10 bytes cheaper to use the previous method
because syncing current_position with lastpos is surprisingly expensive
Don't render full screen for Loading Filament X
this is already done in load_filament_to_nozzle
so no need to do it twice
Change in memory:
Flash: -54 bytes
SRAM: 0 bytes
This fixes an issue where the assumed slot to use is unknown and
the printer will hang on loading filament 100.
Another good thing is this is an old user feature request which
we have in our 3.12 milestone.
Change in memory:
Flash: +14 bytes
SRAM: -1 bytes
If the endstops kick in, then st_get_position_mm shows the actual travel distance. current_position[Z-AXIS] does not get updated correctly thus we cannot use it when unhomed.
current_position[Z-AXIS] is later set to Z_MAX_POS,
we cannot use that either to calculate the travel distance
Removed the "plan" parameter.
We were incorrectly returning from the function if the printer was homed,
but plan = false. This would leave current_position with an incorrect value
If the printer is homed => finish the move and return the travel distance
If the printer is not homed => rely on end stop to prevent damage,
return travel distance even if the endstop stopped the move.
* Created a new function raise_z() which will move the Z axis by some
X millimeters. If plan = false, the function will return the
actual travel distance since the move is blocking.
* raise_z_above() is refactored to call raise_z()
Now the M701 and M702 will move the Z-axis relatively, and also
when done, revert the Z axis position when done.
This is a similar behavior as in Marlin 2.
3d-gussner
Guðni Már Gilbert
Yuri D'Elia
DRracer
Alex Voinea
Yuri D'Elia
D.R.racer