Set a menu block for fatal thermal errors instead of abusing
lcd_return_to_status() to kick the user out of the menus.
This now allows a thermal model error to be recoverable through menu
access.
We allow resuming from the LCD via start print and resume print,
it makes sense to clear the error on stop too.
For this reason distinguish whether the action is performed
automatically or manually (ie: interactively).
The error is only cleared when the command is run interactively.
This prevents the ability to run gcode from the SD card.
In a thermal error with faulty values, and without serial access, this
is the only way to process an M310 instruction and recover.
It's only used when MESH_BED_LEVELING is not defined. According to
the configuration files, all printers supported use MESH_BED_LEVELING.
So I think we are safe in removing this dead code.
The firmware saves the current fanspeed before parking,
and the fanspeed is restored after unparking. The problem is the fan
was never actually paused.
Fixes#3670
This code was introduced with v3.8.0 but was always disabled.
I propose the code be removed since it has not been enabled
for 3 years since its introduction.
- Work-around SOURCE flags being reset for each project when setting the
random-seed property by calling a support function.
- Likewise, set correct flags for reproducibility when creating archives.
- Strip source prefix paths from debug info
This should set the EPOCH using the last git commit date when available,
but it's not currently implemented. Just set the EPOCH to be 0 for now.
We want to move the Z-axis after the XY move is done.
raise_z cannot be used here because it relies
on current_position[] for all axis.
It is actually 10 bytes cheaper to use the previous method
because syncing current_position with lastpos is surprisingly expensive
Don't render full screen for Loading Filament X
this is already done in load_filament_to_nozzle
so no need to do it twice
Change in memory:
Flash: -54 bytes
SRAM: 0 bytes
This fixes an issue where the assumed slot to use is unknown and
the printer will hang on loading filament 100.
Another good thing is this is an old user feature request which
we have in our 3.12 milestone.
Change in memory:
Flash: +14 bytes
SRAM: -1 bytes
Yuri D'Elia
Guðni Már Gilbert
3d-gussner
Alex Voinea
D.R.racer
DRracer
Yuri D'Elia