isEnabled() returns true if the filament sensor state machine is in error state. In most situations we don't want that.
It is sufficient to check if the filament sensor state machine is in Ready state.
Remove `Continue?` from some mesages to save "translation space" and replace multiscreen from `Yes|No` to `Cont.|Cancel`
Remove `Print canceled.` from check messages to save again "translation sapce" and after confirming the message the Status Line shows that it has been stopped.
fix rebase issue
Keep in mind that the EEPROM addresses are in descending order. This means we
can't use eeprom_read_block() or eeprom_update_block()
Address --> Axis
3831 --> X-axis
3830 --> Y-axis
3829 --> Z-axis
3828 --> E-axis
Change in memory:
Flash: -118 bytes
SRAM: 0 bytes
Configuration->HW Setup->Checks showed `a`
MSG_FILAMENT `Filament` can only be 8 chars long and only ES and IT had `Filemanto` as translation.
But as ES the `o` in `Filamento` was overwritten by `[Estricto]` I removed the MSG_FILAMENT to be translated.
Saves few bytes.
A new menu setting is added to configure how strict the check should be.
- None: No check is performed
- Warning (default): The user is warned about missing and is prompted to continue with Yes/No. If No is selected, the print is aborted. If no user input is given (e.g. from host printing) then the warning will expire in 30 seconds and assume the Yes option was selected
- Strict: If the filament is not detected when a print is started, it is immediately canceled.
The check is currently performed on G-codes: M24 and M75. Starting a SD print and Host print respectively.
This fix is no longer needed today.
LCD knob clicks / and rotation, take care of updating lcd_draw_update.
The real bug was likely lcd_show_multiscreen_message_yes_no_and_wait_P calling lcd_update(), this is fixed now since.
- Don't allow re-heating the nozzle or the MMU to unload the filament if the print was aborted by a temperature error
- Allow MMU to unload filament if there is no temperature error, and there is no fan error when Fan check is enabled
- When Fan check is disabled, the MMU may unload if there is no temperature error
Change in memory:
Flash: +14 bytes
SRAM: 0 bytes
PFW-1557
- Show warning if extruder temp is > 40 degrees
- Use fan to speed up cooldown
- Show confirmation msg
- Show nozzle diameter setting after nozzle change
lcd_show_fullscreen_message_yes_no_and_wait_P and lcd_show_multiscreen_message_yes_no_and_wait_P
are the same function. Let's drop one of them so we only have one symbol for the function.
No change in memory
Fix rebase
Guðni Már Gilbert
3d-gussner
sarusani
Alex Voinea
Panayiotis-git
sarusani