Changing (feedrate * feedmultiply) / 6000.f
to (feedrate * feedmultiply) * (1.f / 6000.f)
Replaces the call to __divsf3 with __mulsf3 which is better
No change in memory
lcd_show_fullscreen_message_yes_no_and_wait_P and lcd_show_multiscreen_message_yes_no_and_wait_P
are the same function. Let's drop one of them so we only have one symbol for the function.
No change in memory
Fix rebase
- No wait for heatup during host print recovery
- No extra Z lift when power panic happens during paused print
- added an extra EEPROM value
- fixed `EEPROM_LAST_ITEM`
- changed EEPROM version to 3.14.0
- Added `reset_uvlo` function
cancel_heatup is set to false inside wait_for_heater()
there is no need to do it before the function call
Change in memory:
Flash: -4 bytes
SRAM: 0 bytes
In the case of a Fan Error, the print is paused. If the nozzle is allowed to cool for a while before the print is stopped via the LCD, then the MMU will try to unload with a cold nozzle.
This can happen with ANY recoverable thermal errors.
In this commit I attempt to fix all scenarios. Including PFW-1544 where the nozzle is cooling down when the print has finished normally.
PFW-1544
PFW-1552
Change in memory:
Flash: +74 bytes
SRAM: 0 bytes
If the timer is expired, then the timer is stopped. This is OK since
we are starting the timer again anyway
Change in memory:
Flash: -14 bytes
SRAM: 0 bytes
When long moves are planned and executed the USB timer can expire.
In PrusaSlicer 2.7.1 the Toolchange command (T0, T1, etc.) is sent while the USB timer is expired. This will trigger
a manual MMU unload in the firmware. Not only does this trigger a loud beep from the buzzer, but this will also significantly increase print time.
The issue only affects host prints. SD card printing does not have this issue.
Fixes#4551
The fix in this commit is the following:
If there are blocks queued while printing via host AND the USB timer is halfway expired WHILE executing a move. Then simply restart the timer to keep it alive.
Change in memory:
Flash: +62 bytes
SRAM: 0 bytes
This function is not specific to power panic. Some printer models
do not have power panic enabled.
This change fixes a build failure
No change in memory
3d-gussner
gudnimg
Alex Voinea
sarusani