Remove `Continue?` from some mesages to save "translation space" and replace multiscreen from `Yes|No` to `Cont.|Cancel`
Remove `Print canceled.` from check messages to save again "translation sapce" and after confirming the message the Status Line shows that it has been stopped.
fix rebase issue
Configuration->HW Setup->Checks showed `a`
MSG_FILAMENT `Filament` can only be 8 chars long and only ES and IT had `Filemanto` as translation.
But as ES the `o` in `Filamento` was overwritten by `[Estricto]` I removed the MSG_FILAMENT to be translated.
Saves few bytes.
A new menu setting is added to configure how strict the check should be.
- None: No check is performed
- Warning (default): The user is warned about missing and is prompted to continue with Yes/No. If No is selected, the print is aborted. If no user input is given (e.g. from host printing) then the warning will expire in 30 seconds and assume the Yes option was selected
- Strict: If the filament is not detected when a print is started, it is immediately canceled.
The check is currently performed on G-codes: M24 and M75. Starting a SD print and Host print respectively.
- Show warning if extruder temp is > 40 degrees
- Use fan to speed up cooldown
- Show confirmation msg
- Show nozzle diameter setting after nozzle change
"PRUSA uvlo" is the last g-code to be processed after the power panic
recovery. For host prints, we want to finish processing all these
g-codes and put the print in a paused state.
Currently I am using lcd_pause_print() but this may be simplified
later.
A new PrinterState is introduced PowerPanicWaitingForHost to
differentiate this paused state from the typical paused state.
In this new paused state the printer is waiting for the host to boot up
and send M79.
Once M79 is seen a new action is sent "// action:uvlo_recovery_ready"
It is up to the host software to then resume the print correctly. All
the needed information to resume the print is in EEPROM and can
be read by using the D3 g-code.
Change in memory:
Flash: +82 bytes
SRAM: 0 bytes
- Yes/no question --> Need to fix the bug related with the filename print --> if (lcd_show_fullscreen_message_yes_no_and_wait_P(altfilename, false, LCD_LEFT_BUTTON_CHOICE)==LCD_LEFT_BUTTON_CHOICE)
Host has to send back state with `M72 S1|0` to keep printer and host in sync
Changed LCD menu messages to `Set ready` and `Set not ready`
Updated translations
sarusani
3d-gussner
Alex Voinea
Guðni Már Gilbert
sarusani
Panayiotis-git
Juan Francisco Estrada
D.R.racer