If for some reason a user added a extrusion move in the firmware. Prevent FINDA runout
from triggering.
Change in memory:
Flash: +16 bytes
SRAM: 0 bytes
temp_compensation_start() is only called when
PINDA_THERMISTOR is not defined.
Additionally make sure the retraction or unretraction cannot happen
twice in case MBL fails.
For MK3S users with MMU this extrusion move could
cause a FINDA runout event.
Change in memory:
Flash: -130 bytes
SRAM: 0 bytes
If vSense changes at runtime due to Run current
being changed. Then we must always shift the Hold current
correctly. Whether the vSense is changing 1 -> 0 or 0 ->1
Change in memory (with TMC2130_SERVICE_CODES_M910_M918):
Flash: +76 bytes
SRAM: 0 bytes
If no power panic occurred during M600 we should
clear isPartialBackupAvailable to let the power panic
code know to not use the partial backup. We want the
partial backup ONLY when the extruder is parked after a print is saved.
Change in memory:
Flash: +4 bytes
SRAM: 0 bytes
Remove loading_flag and check for eFilamentAction instead which already
flags both load/unload (in addition to mmu actions).
Correctly transition from AutoLoad to Load as soon as the operation
cannot be cancelled anymore as opposed to resetting it.
All custom commands are transitory and eventually switch back to Idle
state by themselves.
It doesn't make any sense to explicitly check for Layer1Cal: any
non-idle state is active by design.
Fix this check in the main menu. This is probably incomplete (Layer1Cal
is incorrectly used in several other places).
- Always re-calculate the Vsense flag when the currents are changed
- Make sure Hold current is not larger than Run current
- Added SetCurrents() function from MMU FW
- Added MotorCurrents structure from MMU FW
- Various code size optimisations e.g. in power panic
Change in memory:
Flash: -10 bytes
SRAM: +4 bytes
A partial backup is needed in scenarios where the extruder may be
parked after a print is saved. For example during a blocking wait for the user in M600
Or during a MMU error screen.
A sudden power panic at this point would previously save the parked position
into EEPROM. When the print is recovered it would print in mid air.
This allows us to restore the position of all axis saved in RAM
If the extruder had been parked to the side for example
due to filament runout. Then the original position (before parking)
should now be restored
Change in memory:
Flash: +40 bytes
SRAM: 0 bytes
Alex Voinea
Guðni Már Gilbert
3d-gussner
Michael Greene
vintagepc
Guðni Már Gilbert
Yuri D'Elia